Operator`s manual

on the console terminal screen. Now you can enter console commands. If
you inadvertently press the Halt button, type
c Return
to continue. The
VAX 4000 Model 500 Operation manual describes halting the system in
more detail.
CAUTION
Pressing the Halt button halts the system regardless of
the setting of the break enable/disable switch on the
console bulkhead assembly.
Below the Halt button is the Restart/Run button. The Restart/Run
button has a green indicator. When you press the Restart/Run button,
the system returns to a power-on condition and self-tests are run. If
you have a boot device and if the |/O (break/enable disable) switch (see
Figure 1–5) is set to O (disable), the system will reboot system software.
Further instructions on restarting your system are contained in the VAX
4000 Model 500 Operation manual.
NOTE
The Halt and Restart/Run buttons can be disabled to pre-
vent accidental activation. Contact your Digital service
representative if you want to disable the controls on the
SCP.
1–8 System Overview