Operator`s manual

2.8.2 After Installation

Read your system operation manual to learn how to use your system.

While optional, Digital strongly recommends that you run the diagnostic

software before you install system software or start factory-installed

VMS software for the ﬁrst time. The diagnostics verify the system’s

conﬁguration and check to see if each device is working properly. The

diagnostic software is on a tape cartridge labeled MV DIAG CUST TK50.

The VAX 4000 Troubleshooting and Diagnostics manual describes how to

run the diagnostic software.

If you have VMS FIS (factory installed software) on your system, refer

to the VMS Factory Installed Software User Guide for the startup

procedure. Otherwise, install the system software that comes with your

system.

NOTE

Systems that come with FIS have a yellow sticker on the

front panel of the ISE containing the FIS.

2–78 Installation