Operator`s manual

Figure 2–42: Connecting the DSSI Cable
MLO-007160
2.7.3 Connecting the KZQSA External Cable
To connect the KZQSA external cable, perform the following:
1. Find the KZQSA external cable labeled BC06P–06. One end should
be connected to the expander.
2. Remove the terminator from the back connector on the KZQSA
module (see Figure 2–43).
3. Connect the free end of the cable to the connector on the KZQSA
module.
4. Install the terminator removed above on the expander if applicable.
2–64 Installation