Operator`s manual

2.7.2 Connecting the DSSI Cable
To connect the DSSI cable perform the following:
1. Find the DSSI cable labeled BC21M-09. One end should be connected
to the expander.
2. Remove the DSSI terminator from the DSSI In/Out connector labeled
X (see Figure 2–41). Squeeze the spring clips at the top and bottom
of the terminator as you pull it straight out of the bus.
3. Connect the free end of the cable to the DSSI In/Out connector.
Tighten the screws by hand, then use a screwdriver to secure the
connection (see Figure 2–42).
4. Install the terminator (removed above) on the expander, if applicable.
2–62 Installation