Technical data

VAXserver 4000-200 Conversion

4.3 Before Installing the Kit

Before installing the kit:

1. Have the customer back up the system software before the Digital Services

representative arrives. It is the customer’s responsibility to back up the

system software.

2. Turn on the system power and run diagnostics to verify system operation.

3. Turn off the system power before installing the kit.

4.4 Installing the Kit

To install the conversion kit:

1. On a BA215 system, turn the front panel key switch to the bottom position

and remove the front panel as described in Chapter 1. Turn off the system

power switch to the BA215 system.

2. On a BA430 system, unlock the front door by turning the front door key

switch to the bottom position. Swing open both access doors, and turn off

the power switch to the BA430 system.

3. Turn off the system power to any expander boxes connected to the system.

VAXserver 4000-200 Conversion 4–3