User guide

ManualsBrandsVax ManualsDomestic AppliancesV-106AA

www.vax.co.uk

operation

Remove the dirty water tank door from the top of the

dirty water tank (Fig.4/10).

IInsert the up-holstery/stair hose adaptor into the

opening on top of the dirty water tank (Fig.4/11).

Connect the hose solution tube into the fitting on the

lower left side of handle facing carpet washer (Fig.4/12).

Upholstery / stair attachment

Step on power on/off pedal to turn cleaner on.

While depressing solution spray trigger, pull attachment

in backward motion.

Release trigger and push attachment forward in the

same path to remove dirty water and solution from

upholstery. (For heavily soiled areas, repeat if necessary.)

(Fig.4/13).

NOTE: Do not oversaturate the upholstery.

IMPORTANT: For best cleaning results use

steady, moderate, forward and backward

motion. Make sure upholstery is dry before use.

NOTE: If the dirty water tank door is not replaced,

there will be no suction through the nozzle and the

unit will not operate properly.

Power Wash Brush usage

Step on power on/off pedal to turn cleaner on.

Press the button at the back of the Power Wash Brush to

start the rotation of the brushes.

To release the flow of water and solution, press the

trigger and then move the tool in slow circular motions

over the desired area (Fig.4/14).

NOTE: After depressing the trigger there will be a

short time delay before water is dispensed.

NOTE: Although the tool is continually extracting

water from the carpet while switched on, positioning

the front nozzle directly onto the area will allow better

recovery and aid drying.

IMPORTANT: For first use, there may be a 10-15

second delay between depressing the

trigger/button and water being released from the

attachments. This is normal and is not a fault.

NOTE: Battery installation required for powered wash

brush

Fig.4/10

Fig.4/11

Fig.4/12

Fig.4/13

Fig.4/14

back view

V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 8