V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:14 Page 1 Vax careline 0870 6061248 instruction manual Carpet washer Vax model number: V-028PU ULTRA SOLUTION spot & stain remover for homes with www.vax.co.uk Please read carefully before using this cleaner. Always fully extend the mains cable before use. Retain for future reference.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 2 www.vax.co.uk 1. Diagram V-028PU 1 ULTRA 2 22 20 19 10 SOLUTION 18 11 3 12 21 spot & stain remover for homes with 13 4 17 5 9 16 8 14 31 15 7 28 6 23 24 29 Fig.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 3 Vax Careline 0870 606 1248 2. Safety Information FOR HOUSEHOLD USE ONLY. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. 21. Using improper voltage may result in damage to the motor and possible injury to the user. The correct voltage is listed on the rating label. 22. A hazard may occur if the carpet washer runs over the power supply cord.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 4 www.vax.co.uk 3. Assembly Putting your cleaner together Stand base in upright position. Push mid-section onto base by aligning tabs on inside of mid-section with the pockets on the base (Fig.3/1) mid-section Fig.3/4 tabs back view Caddy Assembly pockets Align tool caddy with screw holes on mid-section and base (Fig.3/5). cord base Fig.3/1 Insert 4 lower handle/tool caddy screws (as shown) and tighten until secure (Fig.3/2). Fig.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 5 Vax Careline 0870 606 1248 Cord Storage hose clips Wrap cord around upper and lower cord wraps (Fig.3/7). Clip plug to cord to secure for storage. A upper cord wrap lower cord wrap with quick cord release B Fig.3/10 Continue wrapping hose clockwise, aligning hose into groove on the bottom hose clip (Fig.3/11). Fig.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 6 www.vax.co.uk 4. Operation Preparing the Carpet ! IMPORTANT: Do not use the carpet washer as a dry vacuum. How to Operate Grasp clean water tank under handle while pressing clean water tank latch. Tilt clean water tank away from cleaner and remove (Fig.4/1). 1. Vacuum carpet thoroughly. Use a vacuum cleaner with a revolving brushbar for best results. clean water tank latch 2. Remove as much furniture from the room as possible.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 7 Vax Careline 0870 606 1248 Carpet Cleaning Fill remainder of clean water tank with warm (max 50ºC) tap water. Replace cap (Fig.4/4). Fig.4/7 Fig.4/4 Place bottom of clean water tank into carpet washer and rotate top into position until the clean water tank Latch snaps into place (Fig.4/5). to whilst depressing solution spray trigger, push carpet washer in a forwards motion.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 8 www.vax.co.uk Remove the dirty water tank door from the top of the dirty water tank (Fig.4/10). IMPORTANT: For best cleaning results use steady, moderate, forward and backward motion. Make sure upholstery is dry before use. ! NOTE: If the dirty water tank door is not replaced, there will be no suction through the nozzle and the unit will not operate properly. Fig.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 9 Vax Careline 0870 606 1248 Emptying and cleaning the dirty water tank and filter Remove dirty water tank lid (Fig.4/17). The carpet washer is equipped with a shut off valve within the dirty water tank. When the dirty water tank becomes full, the float will rise, shutting off the air flow through the nozzle. NOTE: The float in the carpet washer will shut off the suction when the dirty water tank is full.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 10 www.vax.co.uk Rinse dirty water tank and filter with warm tap water. Wipe and let dry thoroughly before storing to prevent mildew from forming (Fig.4/20). 5. Maintenance NOTE: Do not use any chemicals when cleaning. Put handle in upright locked position (Fig.5/1). Fig.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 11 Vax Careline 0870 606 1248 6. Troubleshooting ! 7. UK Service & Help WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance or troubleshooting checks. PROBLEM: The cleaner won't run. Cause: Not properly plugged into electrical outlet. Solution: Plug in firmly. Cause: No electricity in electrical outlet. Solution: Check fuse or breaker. Cause: ON/off switch not turned on.
V-028PU User Guide v2.qxd:V-0268PU User Guide 12/3/08 09:15 Page 12 --- EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the Vax V-028PU is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
