Technical data

3.6 Removing a TK-Series Tape Drive
NOTE: The illustrations in this section show the BA440 enclosure.
Duplicating the same basic illustrations for the BA430 enclosure is
unnecessary. The removal procedures are the same for both enclosures.
Remove a TK-series tape drive as follows:
1. Remove the screw at the top of the TK-series drive front panel and tilt
the panel out and down.
2. Remove the tape drive front panel.
3. Release the TK-series drive from its enclosure by loosening the captive
screws above and below the drive unit (Figure 3–18).
Figure 3–18: Releasing TK-Series Captive Screws
MLO-004215
4. Slowly slide the TK-series drive unit partway out of the BA430/BA440
enclosure until you can remove the data cable from the rear of the drive
(Figure 3–20).
BA430/BA440 FRU Removal and Replacement 3–27