Technical data

3.5.2.5 Removing the Interface Card Assembly
Remove the interface card assembly as follows:
1. Unplug the 4-pin power cable, the 50-pin signal cable, and the remote
front panel cable from their connectors on the controller module.
NOTE: Observe cable routing to ensure that you route the cables
properly when reassembling.
2. Lift and remove the plastic interface card assembly being careful to
guide the cables through the cutout in the metal bracket (Figure 3–16).
3. To remove the plastic assembly from the interface card, remove the two
Phillips screws that hold it in place (Figure 3–16).
4. Reverse the procedure to install the interface card assembly.
Figure 3–16: Removing the Interface Card Assembly
Interface Card
Assembly
Phillips
Screws
MLO-005801
BA430/BA440 FRU Removal and Replacement 3–25