Technical data

3.5.2.3 Replacing the Interface Card Assembly
Use the following instructions to replace the interface card assembly (PN
54–20136–03). To remove the interface card assembly, first remove the
upper mounting bracket.
3.5.2.4 Removing the Upper Mounting Bracket
This procedure assumes you have removed the drive as described in
Figure 3–13. Remove the drive upper bracket as follows:
1. Place the drive on an antistatic mat.
2. Remove the two Phillips screws at the rubber shock bushings that
secure the upper bracket to the drive (Figure 3–14).
Figure 3–14: Removing Bracket Screws
MLO-005799
3. Slide the interface card assembly up and lift off the upper bracket
(Figure 3–15).
BA430/BA440 FRU Removal and Replacement 3–23