Technical data

3.5.2.2 Replacing the TLZ04 Front Panel Module
This procedure assumes you have completed steps one and two in
Figure 3–13. Use the following instructions to remove the TLZ04 front
panel module (PN 54–20438–01) and refer to Figure 3–13.
1. Unplug the ID cable from its connector on the TLZ04 panel.
2. Remove the bus node ID plug on the TLZ04 front panel by pulling it
straight out.
3. Lift the plastic tab that holds the front panel module in place and
remove the module.
4. Reverse the procedure to install a module.
Figure 3–13: Removing the TLZ04 Front Panel Module
MLO-005797
35%
Plastic Tab
3–22 BA430/BA440 Enclosure Maintenance