Technical data

4. Reverse the procedure to install the interface card assembly.
Figure 3–9: Removing the Interface Card Assembly
MLO-004257
Interface Card
Assembly
Phillips
Screws
3.5.1.3 Replacing the Remote Front Panel Cable
To remove the remote front panel cable, you first remove the ISE as
described in Section 3.4.1 and the ISE upper bracket as described in
Section 3.5.1.1. After completing those steps, remove the ISE lower bracket
and remote front panel cable. See the following sections.
3.5.1.4 Removing the ISE Lower Bracket
Remove the ISE lower bracket by removing the two Phillips screws at
the rubber shock bushings that secure the lower bracket to the head-disk
assembly (Figure 3–10).
3.5.1.5 Removing the Remote Front Panel Cable
NOTE: Observe cable routing to ensure that you route the cables properly
when reassembling.
To remove the remote front panel cable, unplug the cable from its connector
on the drive module, then pull the cable free from the lower bracket at the
two points where the cable is secured by Velcro. Reverse the procedure to
install the remote front panel cable.
BA430/BA440 FRU Removal and Replacement 3–17