Technical data

Figure 3–8: Removing the ISE Upper Bracket
MLO-004214
Interface Card
Assembly
Upper Bracket
3.5.1.2 Removing the Interface Card Assembly
Remove the interface card assembly as follows:
1. Unplug the 5-pin (RF-series) or 4-pin (RZ-series) power cable, the 50-
pin signal cable, and the remote front panel cable from their connectors
on the controller module.
NOTE: Observe cable routing to ensure that you route the cables
properly when reassembling.
2. Lift and remove the plastic interface card assembly being careful to
guide the cables through the cutout in the metal bracket (Figure 3–9).
3. To remove the plastic assembly from the interface card, remove the two
Phillips screws that hold it in place (Figure 3–9).
3–16 BA430/BA440 Enclosure Maintenance