Technical data

Install TL-series (SCSI) ISEs as follows:
1. Unpack the TL-series ISE.
2. Install the TLZ04 ISE into the upper storage slot 0 only (on the far
right side).
3. With the ISE controller module facing the right, slide the ISE along the
guide rails into a mass storage cavity (Figure 2–6).
NOTE: The first compartment is considered slot 0 or rightmost mass
storage cavity in the upper mass storage area is wider than the rest to
accommodate a larger device such as a tape ISE.
4. Using the upper and lower finger cutouts on the ISE bracketry, firmly
push the ISE brackets until the interface card at the rear of the ISE
plugs into its backplane connector (Figure 2–6). Tighten the two captive
screws.
CAUTION: It is normal for a small gap to come between the ISE
mounting bracket tabs and the frame. Tighten the captive screws only
until they are securely fastened. Do not try to force the tabs to fit flush
against the frame.
5. Plug the remote front panel cable into the module inside the ISE front
panel (Figure 2–6).
6. Attach the ISE front panel to the enclosure by first fitting the panel’s
lower tabs and then the upper tabs into position. Secure the panel with
its single screw (Figure 2–6).
Installation 2–25