Technical data

Figure 2–12: ISE Unit Number Labels
MLO-005364
Attach Unit
Number Label
9
0
10
0
RF-Series RZ-Series
2.6 Installing a TL-Series Tape Drive
The TL-series ISEs are installed the same as the RF-series ISEs. The ISE
front panels have no cable connection to the ISE except for the ID plug. No
other controls or indicators are present on the TL-series front panel. The
TL-series ISE is shown in Figure 2–13.
When installing ISEs, you should first fill all of the available mass storage
compartments in the system enclosure first then install other ISEs into the
expander (if applicable).
CAUTION: Static electricity can damage integrated circuits. Use the wrist
strap and antistatic mat found in the Antistatic Kit (29–26246–01) when
you work with the internal parts of a computer system.
Handle TL-series ISEs with care. Dropping or bumping the ISE can damage
the disk surface.
Installation 2–23