Technical data

4. Using the upper and lower finger cutouts in the ISE brackets, firmly
push the ISE brackets until the interface card at the rear of the ISE
plugs into its backplane connector Figure 2–6. Tighten the two captive
screws.
CAUTION:: It is normal for there to be a small gap between the ISE
mounting bracket tabs and the frame. Do not force the tabs to fit flush
against the frame.
5. Plug the remote front panel cable into the module inside the ISE front
panel.
NOTE:: The ISE front panel for RZ-series ISEs differ inside the ISE
front panel Figure 2–10.
6. Attach the ISE front panel to the enxlosure by first fitting the panel’s
lower tabs and then the upper tabs into position. Secure the panel with
its single screw Figure 2–10
2–20 BA430/BA440 Enclosure Maintenance