Technical data

Figure 2–9: Inserting the TLZ04 Tape Drive Bus Node ID Plug
40%
MLO-005789
Bus Node
ID Plug
Install an ISE as follows:
1. Unpack the ISE
2. Remove the blank IXE front panel from the enclosure. The front panels
are secured with one Phillips screw.
3. With the ISE controller module facing to the right, slide the ISE along
the guide rails into a mass storage cavity Figure 2–10 Install ISEs in
the upper right mass storage area first, then install the next one to the
left of the first.
NOTE:: The first or right-most mass storage cavity is wider than the
rest to asccommodate a larger device. A small filler panel is used to fil
the gap when an RF- or RZ-series ISE is installed in the first storage
cavity.
Installation 2–19