Technical data

2.4.1 Setting Controls on the System
The controls you must set to complete the installation vary, depending
on the CPU and type of disks in the enclosure. Generally, you must
set the baud rate of the console serial line to the same baud rate as the
console terminal, and be sure the fixed disk drives are ready and not write
protected.
Refer to the system’s operation manual for detailed instructions on setting
these controls for the particular system you are installing.
2.4.5 Connecting the Power Cord
Feed the power cord under the system from the rear and attach the power
cord to the connector at the base of the power supply Figure 2–5. Plug the
power cord into the wall outlet when all cabling has been installed.
Figure 2–5: Connecting the Power Cable
MLO-004029
Feed Cable Under System
and Through Opening
Installation 2–11