Technical data

1.11 Console Modules and I/O Panel
The BA430 enclosure uses the H3602 console module which is installed
over slot 2 and slot 3 (the CPU module and one memory module). The I/O
Panel contains two SCSI I/O connectors.
The BA440 enclosure uses the hinged H3604 console module which is
installed on hinge mounted over the CPU and the four memory modules
Figure 1–13.
1.11.1 H3602 Console Module (Used in BA430)
The H3602 console module is used on the BA430 enclosure system. This
module covers two backplane slots (slot 2 and 3). Connect the console
terminal and additional devices as follows:
1.11.2 H3604 Console Module (Used in BA440)
\Figure 1–13)
The H3604 console module is a multifunction module that covers the CPU
and memory locations (4) and is shown in Figure 1–13. The four memory
modules occupy the first four slots on the right side, left of the memory
modules is the CPU, which must occupy the fifth slot.
The H3604 console module Figure 1–13 allows the CPU to interface to a
serial line console device, a DSSI device, and to the Ethernet with the
use of either a ThinWire BNC connector or a standard Ethernet 15-pin
transceiver connector. The hinged H3604 console module has the following
controls, ports, and indicators:
• 100-pin CPU module interface connector
• Baud rate select switch
• Language inquiry switch
• Hexadecimal display
• Halt/Enable switch
• Console serial MMJ connector
• Ethernet selector switch
• Ethernet port features
• Standard Ethernet connector (15-pin)
1–16 BA430/BA440 Enclosure Maintenance