Technical data

1.9.1 Halt and Restart Switch Disable
There are four switches located on the top of the system control panel.
These switches, when positioned off, disable the Halt and Restart button
functions on the SCP. This could be used as a safety feature. When the
upper door is open, these switches protect the system from accidentally
being halted or restarted. Figure 1–11 shows the locationofthe switch pack,
which allows the disabling of the SCP buttons. The factory configuration
is always set to halt and restart enabled (switches on).
Figure 1–11: SCP Enable/Disable Switch Location
1234
-- OPEN --
MLO-004203
Switch Pack
-- OPEN --
Off
On
Factory Setting
1234
Switch position identifications are listed in Table 1–2.
1–14 BA430/BA440 Enclosure Maintenance