Technical data

7. Install the ISEs.
8. Install the tape drive unit and cable (if applicable).
9. Install the modules in their correct slots.
10. Install the fan tray.
11. Install the H3602 CPU cover panel (BA430).
12. Install the H3604 console module (BA440).
13. Connect all external cables.
14. Position the outer shell on the chassis and move it forward toward the
hinge and latching bracket positions.
15. Install two of the self-tapping screws (right side second and fourth from
the bottom) to hold the shell against the chassis (BA430/BA440).
16. Install the right door latching bracket, using the three self-tapping
screws and the 6/32 screw (Figure 3–32).
17. Install the left hinge bracket with the self-tapping screws previously
removed (Figure 3–32).
18. Tighten all screws.
19. Install the upper and lower doors (Figure 3–32). Position the doors at
approximately 90 degrees (half open position) and hook the door over
the hinge bracket pin. They should drop into position.
NOTE: Check and adjust the door latching bracket alignment to ensure
the door latch clears the door latching bracket.
3–44 BA430/BA440 Enclosure Maintenance