Technical data

Installation Note
The four switch pack switches when positioned ON allow the system
controls to function. If the switch pack switches are all positioned OFF,
the system controls on the panel are disabled.
3.8 Vterm Board Removal (BA440 Enclosure Only)
To remove the Vterm board from the BA440 enclosure backplane, follow
the steps below:
1. Open the upper access door.
2. Remove the third tape drive device (if any, counting from the left).
3. Remove the Vterm board from the backplane.
To install a Vterm board, follow the removal procedure in reverse.
BA430/BA440 FRU Removal and Replacement 3–31