User guide

www.vax.co.uk

assembly

3. Assembly

Putting your cleaner together

Remove your Rapide XL from the carton with caution.

The handle is connected to the body by a cord (Fig.3/1).

NOTE: Do not tug or pull on the cord.

Line up the handle to the upper body of the machine and

slide into place (Fig.3/2).

NOTE: Phillips screwdriver required

Secure from the back with the two smaller screws

(Fig.3/3).

Putting your cleaner together.

Feed the cord through the slots on the back of the

handle and push into place (Fig.3/4).

Place a nut into the recess in the back of the upper

handle. While holding the nut in place insert one of the

large screws through the front of the upper handle and

tighten (Fig.3/5).

Repeat the process with the second screw.

Remove the backing tape from the screw cover and press

into place (Fig.3/6).

Clean water tank

NOTE: Make sure the grey wedge block is resting in

place (fig.3/7).

Fig.3/1

Fig.3/4

Fig.3/5

Fig.3/2

Fig.3/6

Fig.3/8

Fig.3/3

V-027U User Guide.qxd:V-027U User Guide 11/3/08 11:46 Page 4