Instruction manual

3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it clicks
into position (Fig.3/1).
2. Push the telescopic extension tube on to the end
of the handle (Fig.3/2).
3. The telescopic extension tube can be lengthened
or shortened by pushing the button in and sliding
the tube apart or together as required (Fig.3/3).
4. Fit the combination floor head or turbobrush
(Model V-091X only) by pushing onto the
extension tube (Fig.3/4).
4. How to Operate
Cord Release
Fully extend the power cord. A yellow mark on
the power cord indicates the recommended
cord length. DO NOT EXTEND THE CORD
BEYOND THIS MARK.
On/off Button
1. Insert the power plug into the electrical outlet.
Make sure the vacuum cleaner is switched off.
2. Press the on/off switch, located on the top of the
vacuum cleaner, to switch on the vacuum cleaner
and press the button again to turn the vacuum
cleaner off.
Carpet Cleaning
For carpet and rug cleaning, press the rocker switch
on the combination floor head to raise the brushes.
Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on
the combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord
rewind button located on the top of the vacuum
cleaner, and guide the power cord with one
hand. Rewind 1-1
1
/
2
metres of cord at a time.
This will prevent the cord from whipping which
could cause damage or injury.
Variable Power
Located between the on/off and cord rewind buttons
there is a variable power dial. Slide this clockwise
and anti-clockwise to adjust the suction power. The
5-stage indicator lights suggest the suction power
for common tasks.
Carry Handle
Lift the carry handle located at the rear end of the
vacuum cleaner to move from room to room. Do not
pick vacuum cleaner up by dirt container handle.
Hose Storage
For convenience there is a slot located on either
side of the vacuum cleaner where the floor tool and
hose can be parked for carrying and storage.
5. Accessories
1. The accessories can be attached directly to the
handle by removing the telescopic tubes and
pushing in the desired accessory.
2. The accessories can also be attached to the
telescopic extension tube for extra reach.
Remove the combination floor head and push on
the desired accessory.
Crevice tool: for crevices, corners and cracks, etc.
Dusting brush: for delicate surfaces.
Upholstery tool: for carpet, upholstery, stairs, etc.
TurboBrush: (Model V-091X only). For pet hair and
larger carpeted areas. NOTE: not recommended
for hard floors.
X-tend: (Model V-091X only).
1. The hose fits directly into the hose inlet on the
vacuum cleaner.
2. The handle fits directly on to the telescopic
extension tube.
3. To release the extra length hose, press the
release clips located on the handle. Refer to
Fig.2/3 on page 4.
4 5
Accessories V-091 & V-091X
1 Dusting brush/Upholstery tool
2 Crevice tool
3 Combination floor head
Additional Accessories V-091X Only
1 TurboBrush
2 X-tend (Extra length suction hose)
Fig.2/2
Fig.2/3
Release clips