Operation Manual

vax.co.uk
6
preparation / troubleshooting
The amount of steam generated can be adjusted by the
knob at the front of the steamer (Fig.4/4).
When not in use (ie. during warm up or cool down after
use) the steam trigger can be locked by sliding the
safety catch to the right (Fig.4/5).
Please note the indicators at the base of the unit:
The right LED illuminates when the steamer is on. The
left LED illuminates when the steamer is ready to use
(Fig.4/6).
5. Troubleshooting
WARNING: To reduce the risk of personal
injury, unplug the vacuum cleaner before
performing maintenance or troubleshooting
checks.
PROBLEM: Appliance does not start.
Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause: Internal fuse blown.
Solution: Have the fuse changed by a qualified
electrician.
Cause: No water in reservoir.
Solution: Fill water reservoir.
PROBLEM: No steam
Cause: No water in reservoir.
Solution: Fill water reservoir.
PROBLEM: Water runs out from the nozzle.
Cause: Too much water in the reservoir.
Solution: Reduce water in the reservoir.
Cause: Appliance tilted too far
Solution: Hold appliance in an upright position.
Cause: Appliance not hot enough.
Solution: Let the appliance heat up for longer before
depressing the steam trigger.
PROBLEM: Water ‘cooks’ during filling.
Cause: Water reservoir still hot.
Solution: Allow to cool before filling.
PROBLEM: Accessory comes loose.
Cause: Accessory not correctly attached
Solution: Refer to user guide for correct fitting
information.
PROBLEM: All solutions exhausted, but steamer is
still not working.
Cause: Appliance may be damaged.
Solution: Contact the Vax Careline.
Fig.4/5
Fig.4/6
!
Fig.4/4
V-084B Series User Guide.qxd:V-084B Infinity User Guide 6/5/09 16:20 Page 6