User guide

8
8. Storage
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet and rewind the power cord
as directed before storing.
NOTE: Always store the vacuum cleaner base
down.
9. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before servicing.
PROBLEM: Vacuum cleaner won't run
C
ause:
N
ot properly plugged into electrical
outlet.
Solution: Plug in firmly.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum
cleaner. Leave for one (1) hour before
switching the vacuum cleaner back on.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of
suction.
Cause:
Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Dust bag full or blocked.
Solution: Replace dust bag.
Cause: Clogged filter.
Solution: Remove clogged filter and replace with
a new one.
Cause: Blockage in hose.
Solution: Disconnect hose, remove obstruction
and then re-fit.
PROBLEM: Accessories won’t pick up.
Cause:
Accessories are not attached correctly.
Solution: Refer to section 5.
PROBLEM: Dust escaping from the vacuum
cleaner.
Cause:
Dust bag full.
Solution: Dispose of dust bag and replace with
a new one.
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Hose not installed correctly.
Solution: Review hose installation.
Cause: Filter not installed completely
.
Solution: Review filter r
emoval and r
eplacement.
S
torage / Troubleshooting
V-076 User Guide 25/8/06 10:47 Page 9