Instruction manual

How to Use Your Vax
Assembling Your Vax:
1. Connect the flexible suction hose,
extendible wand and required tool or
accessory.
2. Insert the flexible suction hose into the air
intake duct on the top of the appliance and
press until it clicks into position. (Fig.1)
3.
The telescopic extension tubes can be
lengthened by pressing the button & sliding
the inner tube to required length. (Fig.2)
Tools and Accessories
Floor Tool
The floor tool has a lever for two positions.
HARD FLOORS: For vacuuming wooden
floors, tiles, linoleum or vinyl covered floors -
use with bristle down.
CARPETS & RUGS: For vacuuming carpets
and rugs - retract bristles.
Attachments
Crevice Tool
For vacuuming sills, narrow openings, edges
and gaps.
Upholstery Brush
For vacuuming upholstery and delicate items.
4 5
Fig.1
Fig.2
Instructions For Use
IMPORTANT: Before using the appliance,
fully extend the power cord but not
beyond the yellow mark and insert the
plug into the power socket. Do not extend
the cord beyond yellow mark.
1. Set the electronic power regulator to MIN
before switching the appliance on. (Fig.3)
2. Press the ON/OFF button to switch the
appliance on. (Fig.4)
3. Suction Power Control
Adjust the power control setting for desired
vacuuming operation (Fig.3). Use of the air
control valve will further regulate the suction
power.
4. Vacuum Air Control Valve
In some instances the vacuuming power
of the cleaner may be too strong. In these
cases, use the vacuum air control valve (on
the handle) to regulate the vacuum suction
power (Fig.5).
Slide the valve
open to reduce
the suction
power.
5. Cord Rewind
To rewind the power cable, press the
rewind button. (Fig.6)
Looking After Your Vax
IMPORTANT: Your Vax is a very powerful
vacuum cleaner. It will collect an extraordinary
amount of dust and dirt, especially during the
first few applications of use, which will quickly
fill the disposable dust bag. Excessive dust
and dirt will also contaminate the pre-motor
protection and air outlet filters.
Any of these conditions usually result in a
noticeable drop-off in suction, or a possible
motor shut down due to thermostat
activation.
On such occasions, it will be necessary to
replace the dust bag, and renew all filters to
regain peak suction and performance.
Dust Full Indicator
When the dust full indicator shows red or when
the suction power reduces substantially, this
indicates that you should change the dust bag.
Attention: If after inserting a new dust
bag, the indicator stays red, this could be
for several reasons:
• Suction passages may be blocked -check
flexible hose and extension tubes, suction
inlet, floor brushes/accessories and nozzles
for obstruction.
• Check pre-motor protection filter
• Check to see if HEPA air outlet filter is dirty.
Fig.3
Fig.4
Fig.5
NOTE: Guide
power cord with
one hand.
Rewind 1-1
1
/
2
metres of cord
at a time. This
will prevent
the cord from
whipping which
could cause
damage or
injury.
Fig.6
Fig.7