Service manual

Servicing the CPU 2-17
Example 2-5 illustrates the steps needed to prepare Kermit with
OpenVMS VAX. What you do is:
1. First make sure that you have the hardware necessary to perform the
task.
2. Make sure you have the correct CD-ROM for the damaged system.
3. Set the terminal speed on the source system to 9600. FRRC only
works at 9600 baud.
4. Run LADCP at the source system to "bind" the CD-ROM volume name
to a virtual disk container pointed to by a logical name created by
LADCP.
5. Next, set the correct parameters for Kermit. Example 2-5 shows how
to run Kermit from a DCL prompt and gives examples of setting the
parameters. The show all command produces a list of Kermit pa-
rameters that should be compared to the parameters shown in Appen-
dix A.
6. Set all parameters in accordance with Appendix A.