Service manual

iv
3.6 Exit ....................................................................................... 3-12
3.7 Display and Verify Commands............................................ 3-14
3.8 How to Update Corrupted Firmware.................................. 3-16
3.9 How to Modify Device Attributes ........................................ 3-18
Appendix A Kermit Parameters
Examples
Example 1-1 Self-Test Display ................................................................. 1-12
Example 2-1 Replacing a Single Processor ................................................ 2-6
Example 2-2 Replacing the Boot Processor ............................................... 2-8
Example 2-3 Adding or Replacing a Secondary Processor...................... 2-10
Example 2-4 Build EEPROM Command ................................................. 2-12
Example 2-5 Setting Up the Source System............................................ 2-16
Example 2-6 Using Kermit to Downline Load FEPROM Code .............. 2-18
Example 3-1 RRD42 LFU Booting ............................................................. 3-2
Example 3-2 Booting LFU .......................................................................... 3-4
Example 3-3 Show Command..................................................................... 3-6
Example 3-4 List Command ....................................................................... 3-8
Example 3-5 Update Command ............................................................... 3-10
Example 3-6 Exit Command..................................................................... 3-12
Example 3-7 Display and Verify Commands........................................... 3-14
Example 3-8 Updating an "Unknown" Device......................................... 3-16
Example 3-9 Modify Command ................................................................ 3-18
Figures
Figure 1-1 LSB Card Cage....................................................................... 1-2
Figure 1-2 LSB Configuration Rules....................................................... 1-4
Figure 1-3 Sample Configuration—2 Processors, 4 Memories ............. 1-5
Figure 1-4 Module Barcode...................................................................... 1-7
Figure 1-5 Removing a Module from the LSB Card Cage...................... 1-8
Figure 1-6 Inserting a Module in the LSB Card Cage ......................... 1-10
Figure 2-1 Sample Hardware Requirements for Remote FEPROM
Recovery................................................................................ 2-14
Tables
Table 1 DEC 7000/VAX 7000 Documentation ..................................... ix