Service manual

2-4 Servicing the CPU
Table 2-1 EEPROM Environment Variables (Continued)
Environment
Variable
Default
Value Variable Description
cpu_enabled
0xff A bitmask determining which CPUs are
enabled to run (leave console mode). If
not defined, all available processors are
considered enabled.
cpu_primary
0xff A bitmask indicating which CPUs are eli-
gible to become the primary processor,
following the next system reset. If not
defined, all available processors are con-
sidered enabled.
d_harderr
Halt Determines action taken following a hard
error. Values are halt and continue.
Applies only when using the test com-
mand.
d_report
Summary Determines level of information provided
by the diagnostic reports. Values are
summary and full. Applies only when
using the test command.
d_softerr
Continue Determines action taken following a soft
error. Values are halt and continue.
Applies only when using the test com-
mand.
dump_dev
Null Device to which dump file is written if
system crashes. (DEC 7000 only)
enable_audit
On If set to on, enables the generation of
audit trail messages used to track boot to
determine location of boot failure.
interleave
Default The memory interleave specification.
Value must be default (memory configu-
ration algorithm that attempts to maxi-
mize memory interleaving is used),
none, or an explicit interleave list.
language
English Determines whether system displays
message numbers or message text. De-
fault value is 36 (English).