Installation guide

Unpacking and Assembling Cabinets 2-7
Use the following procedure to unpack a cabinet:
1. Position the carton so that the front faces an open space with enough
clearance to allow the cabinet to be rolled down ramps.
2. Using a utility knife, cut the shipping straps from the carton.
3. Remove the outside top cardboard cover.
4. Remove the outside shipping box. This is typically done by using a
7/16" socket wrench to remove two bolts that hold the box together.
5. Remove the inside top cardboard cover.
6. Remove the protective plastic wrapping by slipping it up and over the
cabinet.
7. Identify and put aside the components of the cabinet installation kit
which includes two end panels, six end panel brackets, one or two sets
of side, top, and bottom spacers, front and side skirts, and a plastic
bag containing hardware such as nuts and bolts.
8. Locate and remove the two control panel keys for the system cabinet.
The keys are typically tie-wrapped to the system cabinet’s rear grill.
Insert one key into the control panel and put the other key away in a
safe place.
9. Locate the box that contains the ramp kit and open it (see Figure 2-2).
NOTE: It’s a good idea to save all packing materials intact in case the sys-
tem needs to be shipped in the future.