Installation guide

3-2 Console
3.1 Console Commands
Table 3-1 Console Commands
Command Description
boot
Boot the operating system
build
eeprom
Create a new EEPROM image
cdp
Perform basic configuration management of DSSI devices
clear
Clear the specified EEPROM option, remove a boot speci-
fication environment variable, or clear the terminal screen
continue
Resume processing at the point it was interrupted by
Ctrl/P
create
Create an environment variable
deposit
Store data in a specified location
examine
Display contents of a memory location, a register, or a de-
vice
help
Provide basic information on the console commands when
the system is in console mode
initialize
Initialize the entire system or a specified device or subsys-
tem
repeat
Repeat a command; stop by entering Ctrl/C
set
Record the current system configuration in the EEPROM,
set the selected EEPROM option, modify an environment
variable, or connect to another console or service
show
Display the last saved configuration, device information
for a disk or tape adapter, selected EEPROM information,
current state of an environment variable, memory module
information, information about network devices, or system
power status
start
Begin execution of an instruction at specified address;
does not initialize the system
stop
Stop a specified processor