Installation guide

v
8.4 Soft Error Parse Tree........................................................... 8-20
8.5 I/O Port Parse Tree .............................................................. 8-21
8.6 DWLMA Parse Tree............................................................. 8-23
Examples
2-1 Examining the Device Register of VAXBI Node 7 ............... 2-7
3-1 Boot Command — Booting from an InfoServer.................. 3-14
3-2 Cdp Command...................................................................... 3-17
3-3 Show Configuration Command ........................................... 3-18
3-4 Show Device Command ....................................................... 3-19
3-5 Show Network Command.................................................... 3-20
3-6 Show Power Command........................................................ 3-21
4-1 Test Command — System Test ............................................. 4-2
4-2 Test Command — Write/Read/Compare Test of All Disks
Not Associated with Controller "a" ....................................... 4-4
4-3 Test Command — Destructive Exercising Selected, Then
Aborted ................................................................................... 4-6
4-4 Output from Test Command — Quiet Qualifier Set............ 4-6
4-5 Test Command — Detection of Memory Data Compare
Error ....................................................................................... 4-7
4-6 Test Command — Use of Wildcard ....................................... 4-8
4-7 Test Command — Test All Devices Associated with XMI0 . 4-9
4-8 Set Host Command — Running DUP-Based Diagnostics
and Utilities.......................................................................... 4-10
4-9 Set Host Command — Running Diagnostics on a Remote
XMI Adapter, Failing Case.................................................. 4-12
4-10 Set Host Command — Running Diagnostics on a Remote
XMI Adapter, Passing Case................................................. 4-13
7-1 Using the Build EEPROM Command to Restore a
Corrupted EEPROM .............................................................. 7-2
7-2 Booting LFU........................................................................... 7-3
7-3 LFU Display and Show Commands...................................... 7-5
7-4 LFU Update Command ......................................................... 7-6
7-5 LFU Exit Command............................................................... 7-6
7-6 Preparing the Source System to Restore Corrupted
Firmware on a CPU ............................................................... 7-8
7-7 Running Kermit and Setting Parameters ............................ 7-8
7-8 Downline Loading Code to Corrupted FEPROMs................ 7-9
Figures
1-1 LDEV — Device Register....................................................... 1-3
1-2 LBER — Bus Error Register ................................................. 1-3