Instruction manual

Return filter to dirt container. Twist filter clockwise
to lock into position (Fig.5/6).
Return lid to dirt container (Fig.5/7).
Line up arrow on dirt container with unlock/lock
arrows on dirt container lid for proper alignment.
Turn clockwise to lock lid in place (Fig.5/8).
Return dirt container to base of unit and ensure it
clicks securely in to place (Fig.5/9).
6. To Remove Belt
Switch off and remove the plug from mains supply.
Lay cleaner flat and flip cleaner to expose base of
vacuuming head. Base should lay flat and face up.
To remove vacuuming head guard, use a Philips
screwdriver to remove the six (6) screws. Arrows
show the location of screws (Fig.6/1).
Lift vacuuming head guard off (Fig.6/2).
Slide belt off motor shaft (Fig.6/3).
6 7
Fig.5/6
Fig.5/8
Fig.5/9
Fig.6/1
Fig.6/2
Fig.6/3
To Replace Belt or Brushbar
Lift and remove brushbar. Dispose of old belt
(Fig.6/4).
Slide new belt onto motor shaft (Fig.6/5).
Place new belt in area of brushbar without bristles
(Fig.6/6).
With new belt in place, pull and slide brushbar
into vacuuming head making sure that the
brushbar end caps are in the correct
orientation. Rotate brushbar manually to make
sure belt is properly aligned (Fig.6/7).
Re-attach vacuuming head guard (Fig.6/8).
Be sure to replace all six (6) screws (Fig.6/9).
Fig.6/4
Fig.6/5
Fig.6/6
Fig.6/7
Fig.6/8
Fig.6/9
Fig.5/7