User`s guide

KA52/53/54 Firmware Commands

3.2 Console Commands

BOOT Sets the default boot device. The value must be a valid device name or

list of device names as speciﬁed in the BOOT command description in

Section 3.2.1.

HALT Sets the user-deﬁned halt action. Acceptable values are the keywords

"default", "restart", "reboot", "halt", "restart_reboot", or a number in the

range 0 to 4 inclusive.

HOST Invoke the DUP or MAINTENANCE driver on the selected node. Only SET

HOST/DUP accepts a value parameter. The hierarchy of the SET HOST

qualiﬁers listed below suggests the appropriate usage. Each qualiﬁer only

supports additional qualiﬁers at levels below it.

LANGUAGE Sets console language and keyboard type. If the current console terminal

does not support the multinational character set (MCS), then this command

has no effect and the console message appears in English. Values are 1

through 15.

PSWD Allows you to enable or disable the console security feature of the system.

The SET PSE command accepts the following values:

• 0—Console security disabled

• 1—Console security enabled

When the console security feature is enabled, only a subset of the console

commands is available to the user. To enable the complete set of console

commands once the console security feature is enabled, you must use the

PSWD Allows you to set or change the console security password.

RECALL Sets command recall state to either ENABLED (1) or DISABLED (0).

SCSI_ID Sets the SCSI ID of the SCSI controller to a number in the range 0 to 7.

The SCSI ID of the SCSI controller is set to 6 before the system is shipped.

Qualiﬁers: Listed in the parameter descriptions above.

Examples:

>>>

>>>SET BFLAG 220

>>>

>>>SET BOOT DUA0

>>>

>>>SET LANGUAGE 5

>>>

>>>SET HALT RESTART

>>>

3–26 KA52/53/54 Firmware Commands