User`s guide

KA52/53/54 Firmware Commands

3.2 Console Commands

Example:

>>>CONTINUE

$ !OpenVMS DCL prompt

3.2.3 DEPOSIT

The DEPOSIT command deposits data into the address speciﬁed. If you do not

specify an address space or data size qualiﬁer, the console uses the last address

space and data size used in a DEPOSIT, EXAMINE, MOVE, or SEARCH

command. After processor initialization, the default address space is physical

memory and the default data size is longword. If you specify conﬂicting

address space or data sizes, the console ignores the command and issues an

error message.

Format:

DEPOSIT [qualiﬁer-list] {address} {data} [data...]

Qualiﬁers:

Data control: /B, /W, /L, /Q, /N:{count}, /STEP:{size}, /WRONG

Address space control: /G, /I, /M, /P, /V, /U

Arguments:

{address} A longword address that speciﬁes the ﬁrst location into which data is deposited. The

address can be an actual address or a symbolic address.

{data} The data to be deposited. If the speciﬁed data is larger than the deposit data size,

the ﬁrmware ignores the command and issues an error response. If the speciﬁed

data is smaller than the deposit data size, it is extended on the left with zeros.

[{data}] Additional data to be deposited (as much as can ﬁt on the command line).

Examples:

>>>D/P/B/N:1FF 0 0 ! Clear first 512 bytes of

! physical memory.

>>>D/V/L/N:3 1234 5 ! Deposit 5 into four longwords

! starting at virtual memory address

! 1234.

>>>D/N:8 R0 FFFFFFFF ! Loads GPRs R0 through R8 with -1.

>>>D/L/P/N:10/ST:200 0 8 ! Deposit 8 in the first longword of

! the first 17 pages in physical

! memory.

>>>D/N:200 - 0 ! Starting at previous address, clear

! 513 longwords or 2052 bytes.

3–14 KA52/53/54 Firmware Commands