User`s guide

KA52/53/54 Firmware Commands
3.1 Console I/O Mode Control Characters
Table 3–6 (Cont.) Console Command Summary
Command Qualifiers Argument Other(s)
MOVE /B /W /L /Q — /V /P /U
/N:{count} /STEP:{size}
/WRONG
{src_address} {dest_
address}
NEXT — [{count}] —
REPEAT — {command} —
SEARCH /B /W /L /Q — /V /P /U
/N:{count} /STEP:{size}
/WRONG
/NOT
{start_address} {pattern}
[{mask}]
SET BFLAG — {bitmap} —
SET BOOT — [{boot_device}[,{boot_
device}]...
—
SET CONTROLP — {0/1} —
SET HALT — {halt_action} —
SET HOST /DUP /DSSI /BUS:{0/1} {node_number} [{task}]
SET HOST /DUP /UQSSP {/DISK !
/TAPE }
/DUP /UQSSP
{controller_number}
{csr_address}
[{task}]
[{task}]
SET HOST /MAINTENANCE /UQSSP
/SERVICE
/MAINTENANCE /UQSSP
{controller_number}
{csr_address}
SET LANGUAGE — {language_type} —
SET RECALL — {0/1} —
SHOW BFL(A)G — — —
SHOW BOOT — — —
SHOW CONTROLP — — —
SHOW DSSI — — —
SHOW HALT — — —
SHOW LANGUAGE — — —
SHOW MEMORY /FULL — —
SHOW QBUS — — —
SHOW RECALL — — —
(continued on next page)
KA52/53/54 Firmware Commands 3–11