User`s guide

Error Messages
G.4 Console Error Messages
Table G–3 (Cont.) Console Error Messages
Code Message Description
?67 VALUE TOO LARGE The value specified does not fit in the destination.
?68 QUALIFIER CONFLICT Qualifier conflict; for example, two different data sizes are
specified for an EXAMINE command.
?69 UNKNOWN QUALIFIER The switch is unrecognized.
?6A UNKNOWN SYMBOL The symbolic address in an EXAMINE or DEPOSIT
command is unrecognized.
?6B CHECKSUM The command or data checksum of an X command is
incorrect. If the data checksum is incorrect, this message
is issued, and is not abbreviated to "Illegal command".
?6C HALTED The operator entered a HALT command.
?6D FIND ERROR A FIND command failed either to find the RPB or 128 KB
of good memory.
?6E TIME OUT During an X command, data failed to arrive in the time
expected (60 seconds).
?6F MEMORY ERROR A machine check occurred with a code indicating a read or
write memory error.
?70 UNIMPLEMENTED Unimplemented function.
?71 NO VALUE QUALIFIER Qualifier does not take a value.
?72 AMBIGUOUS QUALIFIER There were not enough unique characters to determine the
qualifier.
?73 VALUE QUALIFIER Qualifier requires a value.
?74 TOO MANY QUALIFIERS Too many qualifiers supplied for this command.
?75 TOO MANY ARGUMENTS Too many arguments supplied for this command.
?76 AMBIGUOUS COMMAND There were not enough unique characters to determine the
command.
?77 TOO FEW ARGUMENTS Insufficient arguments supplied for this command.
?78 TYPEAHEAD OVERFLOW The typeahead buffer overflowed.
?79 FRAMING ERROR A framing error was detected on the console serial line.
?7A OVERRUN ERROR An overrun error was detected on the console serial line.
?7B SOFT ERROR A soft error occurred.
?7C HARD ERROR A hard error occurred.
?7D MACHINE CHECK A machine check occurred.
(continued on next page)
Error Messages G–5