User`s guide

FEPROM Firmware Update
6.2 Updating Firmware via Ethernet
Example 6–1 FEPROM Update via Ethernet
***** On Server System *****
$ MCR NCP
NCP>SET CIRCUIT ISA-0 STATE OFF
NCP>SET CIRCUIT ISA-0 SERVICE ENABLED
NCP>SET CIRCUIT ISA-0 STATE ON
NCP>EXIT
$
$ COPY KA50_V41_EZ.SYS MOM$LOAD:*.*
$
***** On Client System *****
>>>b/100 eza0
(BOOT/R5:100 EZA0)
2..
Bootfile: ka50_v12
-EZA0
1..0..
FEPROM update program
---CAUTION---
--- Executing this program will change your current FEPROM ---
Do you want to continue [Y/N] ? : y
Blasting in V1.2-41. The program will take at most several minutes.
DO NOT ATTEMPT TO INTERRUPT PROGRAM EXECUTION
Doing so may result in loss of operable state !!!
+----------------------------------------+
10...9...8...7...6...5...4...3...2...1...0
FEPROM Programming successful
?06 HLT INST
PC = 00008E24
>>>
6. Recycle power or enter "T 0" at the console prompt (>>>).
7. If the customer requires, return the jumper on the module to the "write
disable mode" setting and put the cover on the box.
FEPROM Firmware Update 6–5