User`s guide

System Troubleshooting and Diagnostics
5.2 Product Fault Management and Symptom-Directed Diagnosis
Also, if the system does not have dialout capability, you should answer no when
asked if you want to enable SICL—if you enter yes, the system will attempt
to send mail via DSNLink resulting in error messages. After VAXsimPLUS
is installed you can activate SICL and customize the VAXsimPLUS mailing
lists so that SICL messages are sent to an appropriate destination(s) on site.
This way, SICL messages are received onsite without incurring error messages
regarding remote link failures.
5.2.9.3 VAXsimPLUS Post-Installation Tips
Once VAXsimPLUS is installed, you can set up mailing lists to direct
VAXsimPLUS messages to the appropriate destinations. If the system has
no dialout capability, SICL messages should be directed to the System and/or
Field account—this is good practice for systems with dialout and service center
support as well.
In the example that follows, the four types of mailing lists are displayed and
System and Field accounts are added to all four mailing lists using VAXSIM
/FAULT_MANAGER commands.
Note
The commands can be abbreviated.
DSN%SICL appears under the SICL mailing list if you enabled SICL
during installation.
System Troubleshooting and Diagnostics 5–39