Service manual

The SET BOOT command stores a nickname for a set of parameters to

the BOOT command. (The lower key switch on the control panel must

be set to Update when this command is issued.) This BOOT command

loads VAX/DS from disk. Alternatively, you can use the command

BOOT/R5:10 CSA1 if you have a TK70 as a load device, or you can

boot over the Ethernet from a CD server. For more information on the

BOOT and SET BOOT commands, see any of the VAX 6000 Owner’s

Manuals.

The off-line autosizer program EVSBA identiﬁes hardware on your

system and builds a database for the VAX Diagnostic Supervisor.

The autosizer eliminates the need for you to type in the name and

characteristics of the hardware you intend to test under VAX/DS with

level 3 diagnostic programs.

Diagnostics 2–37