Service manual

Table A–2 (Cont.): Model 300 Standard Console Error Mes-
sages
Error Message Meaning
?3C Secondary processor not in console mode. The primary processor console needed to
communicate with a secondary proces-
sor, but the secondary processor was not
in console mode. STOP the node or re-
set the system to clear this condi-
tion.
?3D Error initializing I/O device. A console boot primitive needed to per-
form I/O, but could not initialize the I/O
adapter.
?3E Timeout while sending message to
secondary.
A secondary processor failed to re-
spond to a message sent from the pri-
mary. The primary sends such mes-
sages to perform console functions on sec-
ondary processors.
?3F Key switch must be at "Update" to
update EEPROM.
A SET command needs to update the EEP-
ROM, but the key switch is not set to al-
low updates.
?40 Specified node is not a bus adapter. A command that accesses a VAXBI node
specified an XMI node that was not a bus
adapter.
?41 Invalid terminal speed. The SET TERMINAL command speci-
fied an unsupported baud rate.
?42 Unable to initialize node. The INITIALIZE command failed to re-
set the specified node.
?43 Processor is not enabled to BOOT or START. As a result of a SET CPU/NOENABLE
command, the processor is disabled from
leaving console mode.
?44 Unable to stop node. The STOP command failed to halt the
specified node.
?45 Memory interleave set is
inconsistent: n n ...
The listed nodes do not form a valid mem-
ory interleave set. One or more of
the nodes might not be a memory ar-
ray, or the set could contain an in-
valid number of members. Each listed ar-
ray that is a valid memory will be config-
ured uninterleaved.
Console Error Messages for Model 300 A–5