Service manual

Example 6–6: RBD 3 — Parameter

RBD3> ST3/TR/T=11:12/C 0A ! Runs <REFERENCE>(XMA2) RBD tests

! T0011 and T0012 from RAM on the

! the memory module in slot A. Confirm

! destructive memory test switch (/C)

! is required on these tests.

;XMA_RBD 3.00

; T0011 T0012

[RBD status messages are printed every two minutes;

use the /DS qualifier in the command string to inhibit

these messages.]

; P 3 8082 1

;00000000 00000000 00000000 00000000 00000000 00000000 00000000

RBD3> QUIT ! Exit from RBD monitor program

?06 Halt instruction executed in kernel mode.

PC = 200601D8

PSL = 041F0604

ISP = 201405B4

>>> ! Console prompt returns

In Example 6–4 note the status message in the display (

). The message

ﬁelds are as follows:

• S = Status message

• 3 = Node from which the RBD is running

• 8082 = Device type of node from which RBD is running

• 1 = Pass 1

• XX = Undeﬁned

• NO_XMA2 = RBD does not perform parts of test 8 on MS65A memories

• 09 = Node where MS65A resides

• T0008 = Test 8 produced the status message

The RBD completes with the normal pass/fail message. Only test 8, the

Interlock Lock Logic Test, behaves this way; all other tests are run on both

MS62As and MS65As.

MS65A Memory 6–23