Service manual

1.3 Identifying the Platform Remotely
Section 1.1 explained how to identify the platform by
inspection. However, persons diagnosing systems remotely
will want to be able to identify system power. While there is
no foolproof method to do this on these systems, the method
given below should work in almost all cases.
Examples of Power Identification Using Show Configuration
1.
>>> SHOW CONFIGURATION !Likely an XMI-1 system
Type Rev
1+ KA64A (8082) 0007
3+ KA64A (8082) 0007
A+ MS62A (4001) 0002
B+ MS62A (4001) 0002
D+ DWMBA/A (2001) 0002
1
E+ DWMBA/A (2001) 0002
1
XBI D
1+ DWMBA/B (2107) 0007
2+ CIBCA (0108) 41C1
5+ DMB32 (0109) 210B
6+ DEBNI (0118) 0100
XBI E
1+ DWMBA/B (2107) 0007
4+ KDB50 (010E) 0F1C
6+ TBK70 (410B) 0307
2.
>>> SHOW CONFIGURATION !Likely an XMI-2 system
Type Rev
4+ KA64A (8082) 0000
8+ MS65A (4001) 0084
9+ MS65A (4001) 0084
A+ CIXCD (0C05) 1611
B+ DEMNA (0C03) 0600
E+ DWMBB/A (2002) 0001
2
XBI E
1+ DWMBB/B (210F) 000A
4+ KDB50 (010E) 131C
6+ KLESI-B (0103) 0006
8+ TBK70 (410B) 0307
3
1–6 VAX 6000 Models 300 and 400 Service Manual