Service manual

5.8 VAX/DS Diagnostics
The <REFERENCE>(xrv) software diagnostics that run
under the VAX Diagnostic Supervisor (VAX/DS) are listed
in Table 5–6. Example 5–4 lists VAX/DS commands used in
testing vector processors. See Section 2.4 for instructions
on running the supervisor.
Table 5–6: <REFERENCE>(XRV) VAX/DS Diagnostics
Program Description
ERKMP Multiprocessor Exerciser
(2 min—quick)
(4 min—default)
EVKAG VAX Vector Instruction Exerciser, Part 1
(1 1/2 min—quick)
(16 min—default)
EVKAH VAX Vector Instruction Exerciser, Part 2
(1 min—quick)
(18 min—default)
Example 5–4: VAX/DS Commands for Testing Vector Processors
DS> RUN ERKMP ! Multiprocessor Exerciser also tests
! vector processors.
DS> SET QUICK ! Abbreviated version of the VAX Vector
! Instruction Exerciser will be run.
DS> DESELECT KA1 ! Removes the second scalar/vector pair
! from testing.
DS> RUN EVKAG ! Part 1 of VAX Vector Instruction Exerciser.
DS> RUN EVKAH ! Part 2.
DS> BOOT n ! If more than one vector, make the other
DS> DESELECT KA0 ! scalar of the second scalar/vector pair
DS> SELECT KA1 ! the boot processor. Run EVKAG and EVKAH
! on the second vector.
DS> BOOT n ! Restore original boot processor.
DS> EXIT
5–16 VAX 6000 Models 300 and 400 Service Manual