Service manual

14. Issue the SET CPU n command to connect the console to the primary

or secondary processor you just replaced.

15. Issue the SET SYSTEM SERIAL command

and follow the command

prompts to correct the error message

16. Use the SET BOOT command supplying the parameters displayed by

the SHOW ALL command to set up the boot alternatives.

17. Use the SET LANGUAGE command to set the language desired.

18. Use the SET TERMINAL command to set the EEPROM terminal

characteristics. These characteristics take effect when the system is

initialized and the EEPROM is read again. Make sure the terminal is

set to the same characteristics.

19. If the CPU you are working on has been designated as ineligible to be

the boot processor, use the SET CPU/NOPRIMARY command to set its

EEPROM correctly.

20. If any patches or boot primitives need to be selected, follow the

procedure in Section 4.18.

21. Turn the lower key switch to the Auto Start position and boot the

operating system.

<REFERENCE>(XRP) Scalar Processor 4–53