User manual

• line_dll – The DLL file name to load CHAPI serial line port from, must be

chapi_serial only

If omitted CHAPI_SERIAL.DLL will be used by default;

• trace_level –

Debug trace level (0 - 10), 0 for NO traces or 10 for MAX traces.

If omitted zero will

be used by default;

• line_cfg – The name of the port to load. Must be:

• seasync – a SEALEVEL PCI 5102S board port

If the line_cfg parameter is omitted, the port name seasync will be used.

• bus_no

SEALEVEL 5102 PCI bus number. If omitted zero will be used by default;

• device_no

- SEALEVEL 5102 PCI device number.

If omitted zero will be used by default;

• function_no

SEALEVEL 5102 PCI function number.

If omitted zero will be used by default;

• rx_clock_direction/tx_clock_direction - Definitions of clock source for transmitting

and receiving. Use IN if you want SEALEVEL 5102S to accept external clock. Use OUT

if you want SEALEVEL 5102S to provide internal clock. If omitted IN will be used by

default;

• interface_mode – SEALEVEL 5102S interface mode. Can be:

• none – all pins are in high impedance;

• rs232 – for SYNC RS-232 interface;

• rs530_422 – for SYNC RS-530(422) interface;

• rs530a – for SYNC RS-530A interface;

• v35 – for V.35 interface;

If omitted NONE will be used by default;

• clock_rate - desired clock rate (300baud – 128KBaud) if OUT direction is selected. If

omitted 9600 will be used by default;

For information about SEALEVEL PCI 5102S sync serial board connector’s pins

definition please refer to its manual (www.sealevel.com).

Examples:

# DPV11, use SEALEVEL 5102S at PCI 1/7/0,