User manual

26
• baudselen – must be true to enable OS baud rate selection
• dtr – must be true to force the DTR signal to ON.
• rts – must be true to force the RTS signal to ON.
• mode – Either ‘E’ or ‘F’ to select DLV11-E or DLV11-F functionality.
• breaken – must be true to enable break generation
• erroren – must be true to enable RX error notification
• char_len – the byte length of transmitted and received characters.
• stop_len – the number of stop bits to be used
• parity – Parity control: “none”, “even”, “odd”, “mark” or “space”
Examples:
# DLV11-E connected to COM port
load chapi TT1 dll=chapi_dlv11.dll
set TT1 address=017760010 vector=0310 trace_level=1
set TT1 line_dll=chapi_serial
set TT1 line_cfg=com
set TT1 line_is_terminal=true
set TT1 line_param=”com=1”
set TT1 baud_rate=9600
set TT1 baudselen=true
set TT1 dtr=true
set TT1 rts=true
set TT1 mode=”e”
set TT1 breaken=true
set TT1 erroren=true
set TT1 char_len=8
set TT1 stop_len=1
set TT1 parity=”none”
# DLV11-E connected to a MOXA NPort 5210, RS232 port 2
load chapi TT1 dll=chapi_dlv11.dll
set TT1 address=017760010 vector=0310 trace_level=1
set TT1 line_dll=chapi_serial
set TT1 line_cfg=moxa
set TT1 line_is_terminal=true
set TT1 line_param=”ip=192.168.127.254 port=2”
set TT1 baud_rate=9600
set TT1 baudselen=true
set TT1 dtr=true
set TT1 rts=true
set TT1 mode=”e”
set TT1 breaken=true