User manual

173
#set TXA line[5]=TXA5
#load np5210_serial_line/chserial TXA6
#set TXA6 ip="xxx.xxx.xxx.xxx" rs_port=n
#load physical_serial_line/chserial TXA6 line="COMn:"
#load virtual_serial_line/chserial TXA6 port=10016
#load virtual_serial_line/chserial TXA6
#set TXA6 port=10016 application="txa6.ht"
#set TXA line[6]=TXA6
#load np5210_serial_line/chserial TXA7
#set TXA7 ip="xxx.xxx.xxx.xxx" rs_port=n
#load physical_serial_line/chserial TXA7 line="COMn:"
#load virtual_serial_line/chserial TXA7 port=10017
#load virtual_serial_line/chserial TXA7
#set TXA7 port=10017 application="txa7.ht"
#set TXA line[7]=TXA7
#
# Configure optional DZV11 (DZQ11) serial line controller (QBUS).
# Address and vector must be set as required by operating system.
#
# Note "/DZ11" specification to load default dz11.dll for the
# device to be created. If it's planned to use custom developed
# DLL specify its name after "/" sign
#
# Note that DZ11 should be used for UNIBUS system.
#
# Once the DLL is loaded, loading of this DLL can be omitted for
# the following instances.
#
# See comments above for different types of serial line
# connections and their parameters.
#
#load DZV11/DZ11 TTA
#load DZQ11/DZ11 TTA
#load DZ11/DZ11 TTA
#set TTA address=... vector=...
#load np5210_serial_line/chserial TTA0
#set TTA0 ip="xxx.xxx.xxx.xxx" rs_port=n
#load physical_serial_line/chserial TTA0 line="COMn:"
#load virtual_serial_line/chserial TTA0 port=10110
#load virtual_serial_line/chserial TTA0
#set TTA0 port=10110 application="tta0.ht"
#set TTA line[0]=TTA0
#load np5210_serial_line/chserial TTA1
#set TTA1 ip="xxx.xxx.xxx.xxx" rs_port=n
#load physical_serial_line/chserial TTA1 line="COMn:"
#load virtual_serial_line/chserial TTA1 port=10111
#load virtual_serial_line/chserial TTA1