User manual

171
#load TUK50/TUK50 MUA
#set MUA address=...
#set MUA container[0]="..."
#set MUA container[1]="..."
#set MUA container[2]="..."
#set MUA container[3]="..."
#
# Configuring the optional DELQA Ethernet adapters (QBUS).
#.
#
# Load the optional DELQA/DESQA/DEQNA Ethernet adapter then load
# a ndis5 packet port then associate these two devices as shown
# below.
#
load DELQA/DEQNA XQA
#load ndis5_chpack_port/chnetwrk XQA0 interface="..."
#set XQA interface=XQA0
#
# Configuring the optional DELUA Ethernet adapters (UNIBUS).
#
# Load the optional DELUA/DEUNA Ethernet adapter then load
# a ndis5 packet port then associate these two devices as shown
# below.
#
load DELUA/DEUNA XUA
#load ndis5_chpack_port/chnetwrk XUA0 interface="..."
#set XUA interface=XUA0
#
# If specifying multiple Qbus/Unibus devices always take care to follow
# Qbus/Unibus addressing rules.
#
#
# Configure optional DHV11 (DHQ11, CXY08, CXA16, CXB16) serial
# line controller (QBUS). Address and vector must be set as
# required by operating system.
#
# Note "/DHV11" specification to load default dhv11.dll for the
# device to be created. If it's planned to use custom developed
# DLL specify its name after "/" sign
#
# "/DHV11" specification can be omitted in case of DHV11
# controller. Once the DLL is loaded, loading of this DLL can be
# omitted for the following instances.
#
# See comments above for different types of serial line
# connections and their parameters.
#
# Note that UNIBUS DHU11 serial line controller is not implemented yet
# for PDP-11/94 emulator. This will be done later. Don't try to use
# described QBUS models with UNIBUS system!
#
#load DHV11/DHV11 TXA
#load DHQ11/DHV11 TXA
#load CXY08/DHV11 TXA
#load CXA16/DHV11 TXA
#load CXB16/DHV11 TXA
#set TXA address=... vector=...
#load np5210_serial_line/chserial TXA0